What Is the Triangle Inequality Theorem? Try Three Paper Strips

What is the triangle inequality theorem? It says that in a triangle, the lengths of any two sides add up to more than the length of the third. The word more matters. If the two lengths add up to exactly the third, you can join all three ends, but the result lies along a straight line. Three strips of paper let you see the difference between closing a loop and actually making a triangle.
What Is the Triangle Inequality Theorem?
For a triangle with side lengths a, b, and c, the theorem gives three inequalities:
- a + b > c
- a + c > b
- b + c > a
If you are given three positive lengths and only want to know whether they can form a triangle, you can check just one of these. Label the lengths so that a ≤ b ≤ c, then test whether a + b > c. Once you include the longest length in a sum, the sum is already larger than either remaining length. For example, a + c is greater than c, and c is at least as large as b. The same reasoning works for b + c.
The longest side does not have to be unique. For lengths 2, 5, and 5, either 5 can be the longest side you test. The check is still 2 + 5 > 5.
Make the Joint Move With Three Paper Strips
Use a ruler to mark lengths of 3, 4, and 6 centimeters on three narrow strips of paper. Put two dots on each strip, one at each end of the measured length. Treat the dots as the endpoints of a side. Lining up dots instead of paper corners keeps the width of the strips from affecting your test.
- Lay the 6-centimeter strip horizontally on a table. Keep it still so it acts as the base.
- Place one dot of the 3-centimeter strip over the left base dot. Place one dot of the 4-centimeter strip over the right base dot.
- Hold each overlapping pair of dots with a fingertip. Rotate the short strips on the tabletop, without bending them or sliding the held dots, until their free dots meet above the base line.
The free dots meet at the third vertex. The three vertices are not on one line, and the triangle encloses an area. Notice what happens if you point both short strips straight inward along the base first. Their combined reach is 7 centimeters, so their free dots pass each other by 1 centimeter. As the strips swing away from the base line, some of that reach goes toward height instead. The free dots can meet without either strip changing length.
At Equality the Strips Lie Flat
Keep the 3- and 4-centimeter strips and replace the base with one that measures 7 centimeters. Point both short strips straight inward. Their free dots meet exactly, 3 centimeters from the left base dot and 4 centimeters from the right one. But the short strips lie along the base. There are three distinct points, all on one line, and no area between the sides.
Try swinging either strip away from the line. It now reaches less far toward the opposite end of the base. The other strip cannot compensate, because it already reached as far as possible when it pointed straight inward. This flat configuration is sometimes called a degenerate triangle. It is why the theorem uses > rather than ≥.
Now try an 8-centimeter base. Even when both short strips point straight inward, there is a gap of 1 centimeter between their free dots. Rotating the strips cannot close the gap. In this case you cannot even get a flat join.
Why the Test Works Beyond the Paper Model
Think of the longest side as the direct route from a point A to a point B. The other two sides give a route from A to B through a third point C. The straight segment is the shortest route. A detour through a point off the line is strictly longer. If C lies between A and B, there is no detour, so the two shorter segments add up to the length of the base.
That explains why the inequality is necessary. To see why passing the test is also enough, imagine using a compass to trace the possible positions of each free dot. The left dot traces a circle centered at A with radius a. The right dot traces a circle centered at B with radius b. With a ≤ b ≤ c, the point on the left circle nearest to B is c − a units from B. If a + b > c, that point is inside the right circle. The farthest point is c + a units from B, so it is outside the right circle. Following the upper half of the left circle from the nearest point to the farthest, you must cross the right circle somewhere above the base line. That crossing is a possible third vertex.
Find the Missing Side Without Drawing It
Suppose two sides measure 5 and 9 centimeters and the third measures x centimeters. You do not know which side is longest, so write the inequalities that restrict x. From 5 + 9 > x, you get x < 14. From 5 + x > 9, you get x > 4. The remaining check, 9 + x > 5, is automatic for a positive length. So the allowed lengths satisfy 4 < x < 14.
For practice writing this as a short solution, see our guide on how to show your work in math. If you want more problems after trying the strip model, visit the IYMC training and practice problems page.
Try drawing the two excluded endpoints. At x = 4, the 4- and 5-centimeter sides lie along the 9-centimeter side. At x = 14, the 5- and 9-centimeter sides lie along the 14-centimeter side. In both drawings the strips meet, but the side that serves as the base has changed.
Frequently asked questions
Do I have to check all three inequalities?
No. For three positive lengths, check whether the two shortest add up to more than the longest. If they do, the other two inequalities automatically hold.
Can 3, 4, and 7 form a triangle?
No. Since 3 + 4 = 7, the strips meet only when they lie along the same straight line, so they enclose no area.
Can the third side be shorter than both given sides?
Yes. For example, 2, 5, and 6 form a triangle because 2 + 5 is greater than 6.



